Kyocera KM-6230 Instruction Handbook Manual page 13

8
Select the connection type: Local or Network.
• Local: The printer is connected directly to the parallel port.
• Network: The printer is connected to the printer via
network (using a network interface).
* If Local is selected, proceed to step 10. If Network is
selected, proceed to step 9.
9
Enter the network queue name or the path for the network
queue in the box.
To select another network queue name, press Browse.
If you are going to use a local port for the network queue,
click the check box displayed below, then proceed to step 10.
Otherwise, proceed to step 11.
10
Select a printer port. From the list, select the desired port,
then click Next.
* Normally, set to LPT1.
* When installing the printer driver for Windows NT, the Add
LPR Port button will appear below the box, so press the
button to set the desired LPR printer.
Section 2 Using the Printer
A name can be assigned to your printer.
11
Specify a new name or select the desired name from the
list, then click Next.
Installation of the printer driver will start.
12 Specify whether this printer is to be used as the default
printer.
Click Yes if so, or click No if not.
13
The settings you have made so far will appear. If they are
correct, click Next.
Installation of the printer driver will start.
14
To exit installation, click End.
* If you want to add another printer driver, click Add Printer
and then repeat the same procedure.
Installation of the printer driver is now complete.
2-4