Kyocera KM-6230 Instruction Handbook Manual page 34

Section 3 Using the Scanner
3
Touch the "Select" key.
4
Select the registration name of the destination computer.
* The registered destination computers will be displayed in
blocks of 10. If you want to select a destination other than
those currently displayed, touch the key on the touch
panel that corresponds to the block of ten numbers which
contains that destination.
5
Touch the "Enter" key.
6
If the destination computer has a login password, type in
that password and then touch the "End" key once again.
3-7
7
If the password that you entered matches the registered
one, the function set-up screen shown below will appear on
the scanner's touch panel.
Change any of the settings as desired. (Refer to "(4) The
Function Set-up Screen" on page 3-9.)
8
Set the original that you want to scan.
9
Press the Start key.
Scanning will begin.
10
Once the scanning operation is complete, select whether
you want to scan another original or not. If you DO want to
scan another original, touch the "Continue" key and repeat
steps 8 through 10. If you are finished scanning originals,
touch the "End" key.