Canon SX50 - REALiS SXGA+ LCOS Projector Command Reference Manual page 53

Commands
LOGOPOS
Function User image position setting
Parameter
Parameter
UPPER_L
UPPER_R
CENTER
LOWER_L
LOWER_R
The RANGE command can be used to obtain the parameter range that can be set at that time.
Response An 'i:OK' is returned after setting is successful.
Description This sets the logo display position.
(1) This command is identical to the Logo position function under User screen settings in the Display settings
menu.
(2) This setting cannot be made unless the user screen is registered beforehand.
(The error "e:1002 NO_LOGO_CAPTURED" is returned.)
(3) The GET command can be used to retrieve the current display position.
Example Setting
> LOGOPOS=UPPER_R
< i:OK
Reference
> GET LOGOPOS or ?LOGOPOS
g:LOGOPOS=LOWER_L
<
Obtain settable parameters
> RANGE LOGOPOS
< r:LOGOPOS=I,UPPER_L,UPPER_R,CENTER,LOWER_L,LOWER_R
*Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
Power supply
OFF ON PM D-RGB A-RGB1 A-RGB2
× ○ × ○ ○
※If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
※When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Meaning
Upper left
Upper right
Center
Lower left
Lower right
Input
Comp Video S-Video
○ ○ ○ ○
This sets the logo display position to the upper right.
This retrieves the logo display position.
Mode
None Remote Local
○ ○ ×
Mode Control Setting
Reference
ID