Canon SX50 - REALiS SXGA+ LCOS Projector Command Reference Manual page 28

Commands
ASPECT
Function Screen setting
Parameter
Parameter Meaning
FULL
NORMAL Normal
WIDE
TRUE
AUTO
The RANGE command can be used to obtain the parameters that can be set at that time.
Response An 'i:OK' is returned after setting is successful.
Description This sets the screen sizes.
(1) The final screen settings are retained even when the power is turned off. However, the screen settings may b
different if the input terminal or input signal is changed.
(2) This command is identical to the Screen settings function in the Display settings menu.
(3) The GET command can be used to retrieve the current screen display mode.
Example Setting
> ASPECT=WIDE
> i:OK
Reference
> GET ASPECT or ?ASPECT
< g:ASPECT=TRUE
Obtain settable parameters
> RANGE ASPECT
< r:ASPECT=I,NORMAL,WIDE,AUTO
*Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
Parameter Power supply
OFF ON PM D-RGB
FULL × ×
○ ○
NORMAL × ○ × ○
WIDE × ○ × ○
TRUE × ×
○ ○
AUTO × ○ × ×
※If a state is not supported, "INVALID_MODE", "NOT_POWER_SUPPLIED" or "INVALID_SOURCE" is returned with the Err response.
※If the required signal input is not available, an 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
※When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Full Screen
Wide
Real
Auto
This sets the screen size to WIDE.
This retrieves the screen size.
Input
A-RGB1 A-RGB2 Comp Video
× ×
○ ○
○ ○ ○ ○
○ ○ ○ ○
× ×
○ ○
× × ○ ×
Mode
Mode
S-Video None Remote Local
× ×
○ ○
○ ○ ○ ×
○ ○ ○ ×
× × ×
○
× ○ ○ ×
Control Setting
Referenc e
ID
e