Canon SX50 - REALiS SXGA+ LCOS Projector Command Reference Manual page 49

Commands
PMM
Function Power management
Parameter
Parameter
STANDBY
The RANGE command can be used to obtain the parameter range that can be set at that time.
Response An 'i:OK' is returned after setting is successful.
Description This sets Power Management mode.
(1) This command is identical to the Power management mode function in the System settings menu.
(2) The Power Management function is disabled when the SX50 is in Remote mode even if Power management
mode is set to Exit mode or Standby mode.
(It is enabled in Local mode only.)
(3) The GET command can be used to retrieve the current Power Management mode.
Example Setting
> PMM=STANDBY
< i:OK
Reference
> GET PMM or ?PMM
g:PMM=EXIT
<
Obtain settable parameters
> RANGE PMM
< r:PMM=I,OFF,STANDBY,EXIT
※Commands are indicated by ">", and responses are indicated by "<"
Supported Command States
Power supply
OFF ON PM
D-RGB A-RGB1 A-RGB2
× ×
○ ○ ○
※If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
※When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Meaning
OFF OFF
Standby mode
EXIT Exit mode
Input
Comp Video S-Video
○ ○ ○ ○
This sets the Power Management mode to "Standby" mode.
This retrieves the Power Management mode.
Mode
None Remote Local
×
○ ○
Mode Control Setting
Reference
ID