Canon SX50 - REALiS SXGA+ LCOS Projector Command Reference Manual page 35

Commands
PROG
Function Progressive setting
Parameter
Parameter Meaning
1
0
The RANGE command can be used to obtain the parameter range that can be set at that time.
Response An 'i:OK' is returned after setting is successful.
Description This sets progressive processing to ON or OFF.
(1) This command is identical to the Progressive function in the Image adj. menu.
(2) This sets the currently selected input signal and image mode.
(3) If the input is set to "Component" and one of the following signals is input, no signal processing is
performed even if the progressive conversion setting is set to ON (progressive conversion).
・1080i
・1035i
(4) The GET command can be used to obtain the current progressive conversion process state.
(1:Conversion process in progress 0: No conversion)
Example Setting
> PROG=0
< i:OK
Reference
>
GET PROG or ?PROG
< g:PROG=1
Obtain settable parameters
> RANGE PROG
< r:PROG=I,0,1
*Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
Power supply
OFF ON PM
D-RGB A-RGB1 A-RGB2
× × × ×
○
※If a state is not supported, "INVALID_MODE", "NOT_POWER_SUPPLIED" or "INVALID_SOURCE" is returned with the Err response.
※If the required signal input is not available, an 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
※When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
ON
OFF
・720p ・480p
・575p
This sets the progressive function to OFF.
This retrieves the progressive function state.
Input
Comp Video S-Video
×
○ ○ ○
Mode
None Remote Local
× ×
○
Mode Control Setting
Referenc
ID
e