Canon SX50 - REALiS SXGA+ LCOS Projector Command Reference Manual page 50

Commands
PJON
Function Display screen setting at startup
Parameter
Parameter Meaning
CANON
SKIP
LOGO
The RANGE command can be used to obtain the parameter range that can be set at that time.
Response An 'i:OK' is returned after setting is successful.
Description This sets the screen displayed at startup.
(1) This command is identical to the Logo position function under User screen settings in the Display settings
menu.
(2) Before a user screen (LOGO) is designated, the user image needs to be registered beforehand. (Otherwise, a
"e:1002 NO_LOGO_CAPTURED" is returned.)
(3) The GET command can be used to obtain the current screen displayed at startup.
Example Setting
> PJON=CANON
< i:OK
Reference
> GET PJON or ?PJON
g:PJON=SKIP
<
Obtain settable parameters
> RANGE PJON
< r:PJON=I,CANON,SKIP,LOGO
※Commands are indicated by ">", and responses are indicated by "<"
Supported Command States
Power supply
OFF ON PM
D-RGB A-RGB1 A-RGB2
× ×
○ ○ ○
※If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
※When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Canon logo
No display
User screen
Input
Comp Video S-Video
○ ○ ○ ○
This sets the startup screen to "Canon logo".
This retrieves the startup screen.
Mode Control Setting
Reference
ID
Mode
None Remote Local
×
○ ○