Canon SX50 - REALiS SXGA+ LCOS Projector Command Reference Manual page 20

Commands
POWER
Function This controls the power supply.
Parameter
Parameter Meaning
ON
OFF
The RANGE command can be used to obtain the parameters that can be set at that time.
Response An "i:OK" is returned after setting is successful.
Description This performs ON/OFF control of the power supply.
(1) This command is identical to pressing the POWER button on the remote control or main unit.
After sending this command, use GET POWER to obtain the power supply state at regular
(2)
intervals, and check that it is in the controlled state (off or on).
(3) The table below shows the POWER command responses according to the power supply state.
POWER Command Responses by Power Supply State
Status
Off
Off→lit
Lamp on
Lit→off
Lit→standby
Standby
Standby→lit
(4) The current mode can be viewed with the GET command.
Example Control
>
POWER ON
<
i:OK
Reference
> GET POWER or ?POWER
< g:POWER=OFF
Obtain settable parameters
> RANGE POWER
< r:POWER=I,ON,OFF
*Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
Parameter Power supply
OFF ON PM
D-RGB
ON ○ ○ ○ ○
OFF
○ ○ ○ ○
※When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Power ON
Power OFF
Command
POWER ON POWER OFF
○ ○
○ ○
○ ○
△ ○
○ ○
○
○
○ ○
Input
A-RGB1 A-RGB2 Comp
○ ○ ○
○ ○ ○
○： i:OK
△： i:BUSY
Video S-Video None Remote
○ ○ ○ ○
○ ○ ○ ○
Mode Control Setting
Referenc
ID
Mode
Local
×
×
e