Advertisement
Model
Ei184 Heat Alarm
Technical Specification
Sensor:
Thermistor
Sensitivity:
Complies with BS 5446 Part 2:
2003
Source:
Contains no radioactive material
Airspeed:
Essentially immune to the effect
of airspeed.
Button Test:
Simulates the effect of heat and
checks electronics and horn.
Supply Voltage:
10.5 to 30VDC
Installation & Placement
Alarms should be placed in accordance with the general guidelines shown in
the diagram above. These recommendations are based on the problem of
areas of "dead air" close to corners of rooms and apexes of ceilings, which
could result in the prevention of heat reaching the heat detector
Please consult the Instruction Leaflet supplied with the Ei184 for detailed
instructions as to how to correctly install and position the heat detector
E & OE As our policy is one of continuous product development, we reserve the right to alter product details without prior
Alarm:
Piezoelectric horn
in unit
Alarm Sound Output: 85dB (minimum) at 3m
Temperature Range: 0 to 40°C
Humidity Range:
0% to 90% Relative Humidity
Fixing:
Screw fixings supplied
Plastic material:
UL94HB flame retardant
Dimensions:
145mm diameter x 75mm depth
Weight:
310 g
Warranty:
5 year (limited) warranty
Approvals:
Kitemarked to BS5446-2:2003, CE
Approved
Specifications are subject to change
Important Precaution:
Do not install the actual smoke/heat
alarm itself in new or renovated
buildings until all work is completed
(including floor coverings) and the
building has been fully cleaned.
(Excessive dust and debris from
building work can contaminate the
smoke chamber and cause
problems, and it will also invalidate
the guarantee). If it must be
installed, cover it completely,
particularly around the edges, with
a dust cover (eg. a plastic bag),
until all cleaning is finished..
Shannon Free Zone, Shannon, Co. Clare, Ireland.
Ph.+353 61 471277 Fx.+353 61 471053
Email.
eielectronics@eiltd.ie
Web:
www.eielectronics.com
Ei184 DataSht RevB
notice.
Advertisement
