Fujitsu Siemens Computers CELSIUS Mobile A Operating Manual page 81

Exiting BIOS-Setup
Diskette drive A error
Ê
Start the BIOS Setup and make sure that the parameter for floppy disk drive A has been set to
the format 1.44 Mbyte, 3 1/2 inch.
Extended memory failed at offset: xxxx Failing Bits: zzzz zzzz
When testing the extended memory an error has resulted at the address xxxx.
Ê
Check whether the additional memory module has been inserted correctly.
Should you receive this error message again, please contact your dealer.
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
Ê
Start the BIOS Setup (IDE Adapter 0 Master submenu) and select the correct settings.
Fixed Disk address conflict Diskette Drive address conflict
There is an I/O address conflict.
Ê
Start the BIOS Setup and check the corresponding settings.
Incorrect Drive A type - run SETUP
Ê
Start the BIOS Setup and make sure that the parameter for floppy disk drive A has been set to
the format 1.44 Mbyte, 3 1/2 inch.
Keyboard controller error
Ê
Switch off the notebook with the Suspend/Resume button.
Ê
Wait 3 - 5 seconds and switch on the notebook again.
If this error message appears again, please contact your point of sale or our hotline/help desk.
Keyboard error
If you use an external keyboard:
Ê
Check the connection and reboot the notebook.
If this error message appears again, please contact your point of sale or our hotline/help desk.
nn Stuck key
Ê
Make sure that no key is pressed.
If this error message appears again, please contact your point of sale or our hotline/help desk.
Operating system not found
Ê
Check in the BIOS Setup whether your hard disk has been set correctly.
Ê
Make sure that the operating system is installed on the corresponding drive.
Not enough Save-to-Disk partition or file exists on Fixed Disk - Save-to-Disk feature is
disabled.
The Save-to-Disk mode is not available to you, as no memory space has been assigned to this
mode.
Ê
Use the PHDISK utility to assign the memory space required for this mode.
A26391-K113-Z120-5-7619
Troubleshooting and tips
71