Ethernet Settings; Table 36. Ethernet Setting Commands - D-Link DWL-8500AP - AirPremier AG Wireless Switching 108 Dualband Access Point Administrator's Manual

D-Link Unified Access Point Administrator's Guide
Table 35. Status Commands
Action
Enable Remote Logging and Specify
the Log Relay Host for the Kernel
Log
Get Transmit / Receive Statistics for
all interfaces
Note: You can also view all transmit
and receive statistics individually.
Get Client Associations
Get neighboring access points
Get information about switches that
can discover and manage the AP

Ethernet Settings

Use the commands in this section to view and set values for the Ethernet (wired) interface.
NOTE: Before configuring this feature, make sure you are familiar with the names of

Table 36. Ethernet Setting Commands

Action
Get Summary View of Internal
Interfaces
Get the DNS Name
Set the DNS Name
Get Current Settings for the
Ethernet (Wired) Internal Interface
Set the management VLAN ID
View untagged VLAN information
Enable the untagged VLAN
Disable the untagged VLAN
Set the untagged VLAN ID
View the connection type
136 © 2001-2008 D-Link Corporation. All Rights Reserved.
the interfaces as described in
The interface name you reference in a command determines whether a setting
applies to a wired or wireless interface, the Internal network, or to radio
"one" or radio "two".
Command
As a prerequisite to remote logging, the Log Relay Host
must be configured first as described in
Logs" on page 92.
Logging command examples:
set log relay-enabled 1
set log relay-enabled 1
get log
TAB TAB shows values you can set on the log
set log
get interface all ip mac ssid tx-packets tx-
bytes tx-errors rx-packets rx-bytes rx-errors
get association detail
get detected-ap detail
get managed-ap
"Interface Naming Conventions"
Command
get bss
get host id
set host id <host_name>
For example:
set host id vicky-ap
get management
set management vlan-id <1-4094>
get untagged-vlan
set untagged-vlan status up
set untagged-vlan status down
set untagged-vlan vlan-id <1-4094>
get management dhcp-status
"Viewing Events
enables remote logging
disables remote logging
on page 132.