Ethernet (Wired) Settings; Wireless Settings; Viewing Events Logs; Figure 18. Viewing And Configuring System Events - D-Link DWL-8500AP - AirPremier AG Wireless Switching 108 Dualband Access Point Administrator's Manual

D-Link Unified Access Point Administrator's Guide

Ethernet (Wired) Settings

The Internal interface includes the Ethernet
Address,
click the Edit link.
For information about configuring these settings, see
page 31.

Wireless Settings

The Radio Interface includes the Radio Mode and Channel. The Wireless Settings section
also shows the
If you want to change the Radio Mode or Channel settings, click the Edit link. For information
about configuring these settings, see
"Configuring Radio Settings"

Viewing Events Logs

The Events Log shows real-time system events on the access point such as wireless clients
associating with the AP and being authenticated.
To view system events, click the Events tab.

Figure 18. Viewing and Configuring System Events

From the Events page, you can view the most recent events generated by this access point and
configure logging settings. You can enable and configure persistent logging to write system
event logs to non-volatile memory so that the events are not erased when the system reboots.
This page also gives you the option of enabling a remote "log relay host" to capture all system
events and errors in a Kernel Log.
NOTE: The Unified Access Point acquires its date and time information using the
92 © 2001-2008 D-Link Corporation. All Rights Reserved.
Subnet Mask, and DNS information. If you want to change any of these settings,
MAC address (read-only) associated with the radio interface.
on page 58.
network time protocol (NTP). This data is reported in UTC format (also
known as Greenwich Mean Time). You need to convert the reported time to
MAC Address, Management
"Configuring the Ethernet Interface"
"Setting the Wireless Interface"
VLAN ID, IP
on
on page 55 and