EdgeStar IP200 Owner's Manual page 8

The "Water" and
The ice shovel cannot
"Ice" indicators
move.
are both flashing.
The ice cycle is too long.
The ice cubes
stick together.
The water temperature in
the inner tank is too low.
The unit is being run off
The compressor the wrong voltage or
makes a loud frequency.
buzzing noise
The
damaged in shipping.
The unit does Power is not supplied to
nothing the unit.
The ambient temperature
or the water temperature
The ice making
is too high.
cycle seems
normal but no ice
Refrigerant leakage.
is produced.
A pipe in the cooling
system is blocked.
Check if the ice is blocking the ice
pusher, otherwise, consult service.
Stop the ice maker, and restart it
when the ice blocks melt. Select
the small ice button.
Change the water in the inner tank.
The ideal water temperature is
45°-90°F.
Plug the unit into a 110/120 Volt,
60 Hertz power source.
compressor was
Contact the shipper.
Plug the unit into a 110/120 Volt,
60 Hertz power source.
Please run the ice maker in
temperatures below 90°F and/or
pour colder water into tank.
Consult a qualified technician.
Consult a qualified technician.
6