Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for EdgeStar IP300P
Summary of Contents for EdgeStar IP300P
-
Page 2: Table Of Contents
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS…………………………………………………1 PREPARING YOUR ICE MAKER FOR USE IMPORTANT SAFETY TIPS.……………………………………………………………….2 GETTING TO KNOW YOUR UNIT OPERATING PROCEDURES & MAINTENANCE UNPACKING YOUR ICE MAKER ..………….…………………………………………...4 CONNECTING YOUR ICE MAKER……………….……….……………………………..4 CLEANING AND MAINTAINING YOUR ICE MAKER….……………………………….4 USING YOUR ICE MAKER……………….……..………………………………………...5 TROUBLESHOOTING...……………………….……………………………………………6... -
Page 3: Important Safety Instructions
TABLE OF CONTENTS and INTRODUCT IMPORTANT SAFETY INSTRUCTIONS ION Your safety and the safety of others is very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol: All safety messages will follow the safety alert symbol and the word “DANGER”... -
Page 4: Preparing Your Ice Maker For Use
Do not tip over. Do not operate with side or back panels removed. If the ice maker is brought in from outside in wintertime, give it a few hours to warm up to room temperature before plugging it in. -
Page 5: Getting To Know Your Unit
GETTING TO KNOW YOUR UNIT... -
Page 6: Operating Procedures & Maintenance
3. Find a location for your ice maker that is protected from direct sunlight and other sources of heat (i.e., stove, furnace, radiator). Place the ice maker on a level surface. Maker sure that there is at least 5 inches of space between the back and sides of your ice maker and the wall. -
Page 7: Using Your Ice Maker
8. Change the water in the water reservoir periodically to ensure cleanliness and hygiene. 9. It is best to use tap water or bottled drinking water in the ice maker. Distilled water may not work. If you do use distilled water and the ice maker will not function, try adding a little salt into the water (a small amount of salt added to the water should be imperceptible). -
Page 8: Troubleshooting
A pipe in the cooling system is blocked. SOLUTION Stop the ice maker, fill it with water, and then restart it. Open the drain cap on the back of the unit and drain out a small amount of water. Replace the drain cap and attempt to use the unit again. -
Page 9: Technical Specifications & Circuit Diagram
TECHNICAL SPECIFICATIONS & CIRCUIT DIAGRAM TECHNICAL SPECIFICATIONS CIRCUIT DIAGRAM... -
Page 10: Limited Warranty
For information on EdgeStar and to view our full line of products, please visit our website: http://www.edgestar.com EdgeStar Products Box 81336 Austin, Texas 78708-1336 Toll Free: 1-866-319-5473...
Need help?
Do you have a question about the IP300P and is the answer not in the manual?
Questions and answers