EdgeStar IP200 Series Instruction Manual

“ice shovel” installation

Hide thumbs Also See for IP200 Series:

Download this manual See also: Owner's Manual

"Ice shovel" installation for IP200* series

NOTE: This instruction guide assumes a) the ice shovel piece is already removed from

your ice maker and b) the "water bucket" piece and hinges for the ice shovel are currently

properly installed. See fig. 1 for an image of the ideal condition of the ice maker prior to

beginning this installation.

Fig. 1:

In order to properly complete this installation, you need 1 plastic ice shovel part, 2 metal

pins, and a pair of needle nose pliers.

Step 1:

Partially insert 1 pin into one side of the ice shovel, as shown in fig. 2.

Fig. 2:

Need help?

Do you have a question about the IP200 Series and is the answer not in the manual?

Page 1 “Ice shovel” installation for IP200* series NOTE: This instruction guide assumes a) the ice shovel piece is already removed from your ice maker and b) the “water bucket” piece and hinges for the ice shovel are currently properly installed. See fig. 1 for an image of the ideal condition of the ice maker prior to beginning this installation.
Page 2 Step 2: Position the ice shovel piece about the hinges as shown in fig. 3a, then carefully push the pin further in, making sure to insert the pin through the hole in the hinge (it is often easiest to use a pair of needle nose pliers for this step). See fig. 3b. Fig.
Page 3 NOTE: At this point, your ice maker should look something like fig. 4. Fig. 4: Step 3: Repeat Step 2 for the other side of the ice shovel. See fig. 5: Fig. 5:...
Page 4 Your installation should now be complete. The ice maker should look like fig. 6. Fig. 6: Here is a closer view of the hinge of an ice maker after installing a new ice shovel- fig. 7. Fig. 7:...