Powered Pet Hair Cleaning Tool - Hoover U8347 Owner's Manual

Powered pet hair cleaning tool

Agitator brush roll
When agitator brush roll brushes on
the powered pet hair cleaning tool
are worn, the agitator brush roll should
be replaced. Ask for HOOVER part
No. 48414088.
How to replace
1. Remove tool from hose and
46
turn it so bottom faces up. Press
the latches on either side of tool and
remove bottom plate (A).
D
5. Insert agitator brush roll
49
through belt and position belt
over gear teeth (D) on agitator brush
roll.
14
2. Unscrew the two Phillips
47
A
screws and remove belt guard
(B).
C
6. With curved ends down,
50
slide end plates (C) of agitator
brush roll into slots (E) on tool.
B
3. Remove agitator brush roll
48
including end plates (C) and
discard.
4. Inspect belt to ensure that it is in
good condition. If belt is cracked,
gouged or broken, replace it (see fol-
lowing section).
B
E
7. Replace belt guard (B) mak-
51
ing sure not to pinch brush bris-
tles in guard. Turn agitator brush roll,
to make sure it rotates freely.
Replace and tighten screws.
C