Table of Contents
Advertisement
4.0
Voltage Booster Unit Installation and Wiring
4.1
Nomenclature Descriptions:
ATO...the fuse configuration is ATO. When replacing this fuse, ask for an ATO fuse.
"a"...Amperage.
Important: The wiring hardware and instructions included with this kit are intended for 12-volt electrical
systems only. Before attempting to wire your Edelbrock Performer Nitrous Oxide System, examine and follow
the wiring diagram on the following page. Please call the Edelbrock Technical Department with any
questions concerning electrical wiring.
When working with electrical systems in your vehicle, it is a good idea to have a service manual that features your vehicle.
It is also good practice to have a book that specializes on the specialized techniques required when working with
vehicular electrical systems.
©2002 Edelbrock Corporation
Brochure No. 63-0029
Voltage Booster Relays Bill of Materials
Quantity
Description
2 ea.
30 amp Relay
2 ea.
Wire Harness with Integral Relay/Fuse Holder
2 ea.
15 amp ATPO Blade Fuse
2 ea.
16/18, Splice Connector
1 ea.
14/16g 3/8" Ring Terminal, Nylon Insulated
2 ea.
14-16g Male Spade Connector, Nylon Insulated
2 ea.
14-16g Female Spade Connector, Nylon Insulated
2 ea.
Butt Connector
Page 18 of 26
Rev. 12/02
Advertisement
Table of Contents
