Cars; (Japanese-Cars) - Kenwood KDC-519 Instruction Manual

Installation (non-Japanese cars_
Firewall or metal support
Screw (M4XS)
(commercially
available) ,-
Installation (Japanese-cars_
Factory-installed
Radio Bracket
Accesso ry(_}
J-Car Bracket
(follow indications for L/R)
Factory-installed
Radio Bracket
Bend tile tabs of tile
i mounting sleeve with
a screwdriver or similar utensil and attach it in
Phillips truss head Metal mounting strap place.
sheet metal screw (commercially
(commercially available) available)
_ ake sure that the unit is installed securely in place. If tile unit is
unstable, it may malfunction (for example, the sound may skip).
Factor_trim bezel
(place thick bottom)
/_ To attach this unit, make sure the front of the control panel faces you
and fit it into the mounting sleeve by pressing the four corners of the
hard rubber frame at the same time.
Do not apply strong pressure to other sections than the corners;
otherwise troubles such as the impossibility of opening or closing the
panel may result.
Toyota Car For Nissan Car
After aligning the factory- After aligning the J-Car
installed radio bracket, bracket with the factory-
tighten the screws, installed radio bracket,
tighten the screws.
_ Is...... AccessoryL_)
1_4 for Toyota car 8 ...... Accessory,}
for Nissan car
_mm I--I
smm
Z_ Damage to the unit will result from using screws other than those
provided.
A pair of J-Car Brackets (Accessory (_}) are not used when fitting
in a Toyota car.
\ J
--25--