Volume; Audio Control; Speaker & Woofer Setting - Kenwood KDC-Z939 Instruction Manual

Cd receiver
Hide thumbs Also See for KDC-Z939:
Table of Contents

Advertisement

General features

Audio Control

1
Select the source for adjustment
Press the [SRC] button.
2
Enter Audio Control mode
Press the [AUD] button for at least 1 second.
3
Select the Audio item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed the items that can be adjusted
switch as shown below.
4
Adjust the Audio item
Press the [4] or [¢] button.
Adjustment Item
Display
Bass Center
"Bass FRQ"
Frequency
Bass level
"Bass"
Bass Q Factor
"Bass Q"
Bass Extend
"Bass EXT"
Middle Center
"Middle FRQ"
Frequency
Middle level
"Middle"
Middle Q Factor
"Middle Q"
Treble Center
"Treble FRQ"
Frequency
Treble level
"Treble"
Balance
"Balance"
Fader
"Fader"
Non-Fading level*
"NF Level"
Front High Pass Filter "HPF Front"
Rear High Pass Filter "HPF Rear"
Range
60/70/80/100 or 150
(Hz)
–8 — +8
1.00/1.25/1.50/2.00
ON/OFF
0.5/1.0/1.5/2.0
(kHz)
–8 — +8
1.0/2.0
10.0/12.5/15.0/17.5 (kHz)
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15
–15 — +15
Through/40/60/80/100/120/
150/180/220
(Hz)
Through/40/60/80/100/120/
150/180/220
(Hz)
— 10 —
Non-Fading
"LPF NF"
Low Pass Filter*
Non-Fading Phase*
"NF Phase"
Volume offset
"Volume Offset"–8 — ±0
• According to the Bass Q Factor setting value, the frequencies that
can be set in Bass Center Frequency change as shown below.
Bass Q Factor
1.00/1.25/1.50
2.00
• When the bass extend is set to ON, low frequency response is
extended by 20%.
• Volume offset: Each source's volume can be set as a difference
from the basic volume.
*:
This mode is available only when <Non-fading Output> (page
18) is ON.
5
Exit Audio Control mode
Press the [AUD] button.
Speaker & Woofer Setting
Speaker setting allows the System Q settings to be fine-tuned
according to the type of speakers.
Woofer setting allows for Network configuration according to the
type of subwoofers.
1
Enter Standby
Press the [SRC] button.
Select the "ALL OFF" display.
2
Enter Speaker & Woofer Setting mode
Press the [Q] button.
"Speaker Setting" is displayed.
50/80/120/Through
(Hz)
Normal (0°)/Reverse (180°)
Bass Center Frequency
60/70/80/100
60/70/80/150

Advertisement

Table of Contents
loading

Table of Contents