System Q; Audio Control - Kenwood KDC-9023R Instruction Manual

5
Select the Audio Control item for adjustment
Press the [2] — [5] button.
Each time the [2] — [5] button is pressed the adjustable audio
items are switched among ranges of all stage section's tables on
the following pages.
6
Adjust the Audio Control item
Press the [4] or [¢] button.
Each time the button is pressed the setting switches as shown
below.
7
Exit Audio Control mode
Press the [RTN] button.
• The loudness setting can also be adjusted by pressing the [4]
button.
• WOW can be set when SRS WOW or User memory is selected at
<System Q> (page 10).
*
• This mode is available only when <Non-fading Output> (page
18) is ON.
• The Loudness can not be set when SRS WOW is selected at
<System Q> (page 10).
1st section
[2] button
Adjustment Item Display
Bass Center "Bass FRQ"
Frequency
Bass level "Bass"
Bass Q Factor "Bass Q"
Bass Extend "Bass EXT"
Range
60/70/80/100 or 150 Hz
–8 — +8
1.00/1.25/1.50/2.00
ON/OFF
— 11 —
[3] button
Adjustment Item Display
Middle Center "MID FRQ"
Frequency
Middle level "MID"
Middle Q Factor "MID Q"
[4] button
Adjustment Item Display
Treble Center "TRE FRQ"
Frequency
Treble level "TRE"
[5] button
Adjustment Item Display
Balance "Balance"
Fader "Fader"
• According to the Bass Q Factor setting value, the frequencies that
can be set in Bass Center Frequency change as shown below.
Bass Q Factor
1.00/1.25/1.50
2.00
• When the bass extend is set to ON, low frequency response is
extended by 20%.
Range
0.5/1.0/1.5/2.0 kHz
–8 — +8
1.0/2.0
Range
10.0/12.5/15.0/17.5 kHz
–8 — +8
Range
Left 15 — Right 15
Rear 15 — Front 15
Bass Center Frequency
60/70/80/100
60/70/80/150