Panel Position Setting - Kenwood KDC-9023R Instruction Manual

Panel Position Setting

Setting the angle or back-forward position of the control panel.
1
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "PNL" is displayed above the [4]
button.
2
Enter Panel Position Setting mode
Press the [4] ("PNL") button.
3
Select the item for adjustment
Press the desired [2] — [5] button.
Each time the button is pressed the items that can be adjusted
switch as shown below.
Adjustment Item
The panel tilts upwards
The panel tilts downwards
The panel slides backward
The panel slides forward
4
Exit Panel Position Setting mode
Press the [RTN] button.
The control panel may be interfered with the shift lever or another
part depending on the angles of the control panel.
Set the angle to avoid any interference.
No sound is produced while the panel is operating.
Button Display
[2] "ANG–"
[3] "ANG+"
[4] "SLD–"
[5] "SLD+"
— 19 —