Kenwood KDC-9023R Instruction Manual page 55

?
There's no Front High Pass Filter and Rear High Pass Filter
The Non-fading preout is being used.
There's no effect in Non-fading preout.
?
The Touch Sensor Tone doesn't
The preout jack is being used.
The Touch Sensor Tone can't be output from the preout jack.
?
Even though Synchronize Clock is ON, the clock can't be
The received RDS station isn't sending time data.
Receive another RDS station.
?
The Dimmer function doesn't work.
The Dimmer wire isn't connected correctly.
Check the Dimmer wire connection.
?
The panel is not hidden even when the power is turned off.
The protection function for preventing fingers or other things from
getting caught in between the panel and this unit has been activated.
Turn off the power again.
?
Sound is interrupted when Dual Zone System is set to
When Dual Zone System is set to ON while the Menu system's <AF
(Alternative Frequency)> (page 43) is set to ON, the sound quality
may be adversely affected if the internal source is set to the tuner.
---
?
There are no audio control effects.
WOW item on <Audio Control> (page 10) and SRS WOW item on
<System Q> (page 10) have no effect in rear output.
---
effect.31
sound.34
adjusted.35
38-1
38-3
ON.38-4
Tuner source
?
Radio reception is poor.39
The car antenna is not extended.
Pull the antenna out all the way.
The antenna control wire is not
Connect the wire correctly, referring to the section on
<Connecting Wires to Terminals>.
?
The desired frequency can't be entered with the Direct Access
Tuning.41
A station that can't be received is being entered.
Enter a station that can be received.
You're trying to enter a frequency with a 0.01 MHz
What can be designated in the FM band is to 0.1 MHz.
?
It isn't the set Traffic information sound volume.
The set sound volume is less than the tuner sound volume.
If the tuner sound volume is louder than the set sound volume,the
tuner sound volume is used.
Disc source
?
"AUX1" is displayed without achieving External disc control
Unsupported disc changer is
Use the disc changer mentioned in the IMPORTANT
INFORMATION of the section on <Safety precautions> (page 3).
?
The specified disc does not play, but another one plays
The specified CD is quite dirty.
Clean the CD.
The disc is loaded in a different slot from that
Eject the disc magazine and check the number for the specified
disc.
The disc is severely scratched.55
Try another disc instead.
?
A CD ejects as soon as it is
The CD is quite dirty.63
Clean the CD, referring to the CD cleaning of the section on
<About CDs> (page 5).
— 55 —
connected.40
unit.42
43
connected.51
instead.52
specified.54
loaded.62
mode.50