Kenwood KDC-9023R Instruction Manual page 56

Troubleshooting Guide
?
Can't remove disc.64
The cause is that more than 10 minutes has elapsed since the vehicle
ACC switch was turned OFF.
The disc can only be removed within 10 minutes of the ACC
switch being turned OFF. If more than 10 minutes has elapsed,
turn the ACC switch ON again and press the Eject button.
?
The disc won't insert.65
There's already another disc inserted.
Press the [0] button and remove the disc.
?
Direct Search can't be done.66-1
Another function is ON.
Turn Random Play or other functions OFF.
?
Track Search can't be done.66-2
For the discs/folders first or last song.
For each disc/folder, Track Search can't be done in the backward
direction for the first song or in the forward direction for the last
song.
MP3/WMA source
?
Cannot play an MP3/WMA.67
The media is scratched or dirty.69
Clean the media, referring to the CD cleaning of the section on
<About CDs> (page 5).
?
The sound skips when an MP3/WMA is being
The media is scratched or dirty.
Clean the media, referring to the CD cleaning of the section on
<About CDs> (page 5).
The recording condition is bad.73-2
Record the media again or use another media.
?
The MP3/WMA track time isn't displayed
---
There are times when it isn't displayed correctly according to the
MP3/WMA recording conditions.
If the following situations, consult your nearest service
center:
Even though the disc changer is connected, the Disc Changer source is not
ON, with "AUX1" showing in the display during the Changer Mode.
The messages shown below display your systems
condition.
Eject:
No Disc:
TOC Error:
E-05:
Blank Disc:
played.73-1
No Track Disc:
E-15:
No Panel:
correctly.80
E-77:
— 56 —
No disc magazine has been loaded in the changer. The disc
magazine is not completely loaded.E01
Load the disc magazine properly.
No CD in the unit.
Insert the CD.
No disc has been loaded in the disc magazine.E02
Load a disc into the disc magazine.
No disc has been loaded in the disc magazine.E04
Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD is
scratched a lot.
Clean the CD and load it correctly.
The CD is upside-down.E05
Load the CD correctly.
Nothing has been recorded on the MD.E10
No tracks are recorded on the MD, although it has a
Media was played that doesn't have data recorded that the
unit can play. E15
Use media that has data recorded that the unit can play.
The faceplate of the slave unit being connected to this unit
has been removed.E30
Replace it.
The unit is malfunctioning for some reason.E77
Press the reset button on the unit. If the "E-77" code does
not disappear, consult your nearest service center.
title.E11