Setting Up The Hands Free Phone - Kenwood DDX8032BT Instruction Manual

Hands Free Unit Control
If you hear another Beep sound:
Speak the key word within 2 seconds after the
Beep, or touch the [Phonebook List] button to
select the phone number.
Make a call.
⁄
• If there are more than one phone numbers registered
under the same name, and the key word voice is
registered for each phone number, you will hear another
beep. For how to register key word, see <Key Word Voice
Registration> (page 56).
If there are more than one phone numbers
registered under the same name, go to step
3.
3 Select a Phone number category
4
6
5
4 Calls the displayed phone number.
5 Creates an SMS to the displayed address.
See <SMS (Short Message Service)> (page
58).
6 Selects the Phone number category.
7 Scrolls the phone number.
8 Returns to the Hands Free Control screen.
4 Make a call
⁄
• A message is displayed if the voice is not recognized.
Read the message for the further operation.
54 DDX8032BT/DDX8032BTM

Setting Up the Hands Free Phone

The Hands Free system can be set as follows.
1 Display the Hands Free Setup screen
2 Setup each item
7
8
1 Moves to the "Hands Free Setup 2" screen.
2 Sets an automatic response time after call
3 Sets a ringing tone output position.
4 Sets the beep of the incoming call.
2
3
4
5
7
8
9
10
11
termination. ( "8")
"Off": This function can not use.
"0-99": Sets to calling ring time (second).
( "Front R")
"Front L": Outputs the tone from the front
left-hand side speaker.
"Front R": Outputs the tone from the front
right-hand side speaker.
"Front All": Outputs the tone from the both
front speakers.
( "On")
"ON": Beep is heard.
"OFF": Beep is canceled.
1
6
12