Setting Up The Hands-Free Phone - Kenwood DNX5240BT Instruction Manual

If you hear another Beep sound:
Speak the key word within 2 seconds after the
Beep, or touch the [Phonebook List] button to
select the phone number.
Make a call.
⁄
• If there are more than one phone numbers registered
under the same name, and the key word voice is
registered for each phone number, you will hear another
beep. For how to register key word, see <Key Word Voice
Registration> (page 53).
If there are more than one phone numbers
registered under the same name, go to step
3.
3 Select a Phone number category
3
5
4
3 Calls the displayed phone number.
4 Creates an SMS to the displayed address.
See <SMS (Short Message Service)> (page
55).
5 Selects the Phone number category.
6 Scrolls the phone number.
7 Displays the Phonebook data list.
8 Returns to the Hands-Free Control screen.
4 Make a call
⁄
• A message is displayed if the voice is not recognized.
Read the message for the further operation.

Setting Up the Hands-Free Phone

The Hands-Free system can be set as follows.
1 Display the Hands Free Setup screen
2 Setup each item
6
7
8
10
11
1 Moves to the "Hands Free Setup 2" screen.
2 Sets an automatic response time after call
termination. (
"Off":
"0-99": Sets to calling ring time (second).
3 Sets a ringing tone output position.
(
"Front L": Outputs the tone from the front
"Front R": Outputs the tone from the front
"Front All": Outputs the tone from the both
4 Sets the beep of the incoming call.
(
"ON": Beep is heard.
"OFF": Beep is canceled.
2
3
4
5
7
8
9
"8")
This function can not use.
"Front All")
left-hand side speaker.
right-hand side speaker.
front speakers.
"ON")
1
6
12
Next page 3
English 51