Power Led - HP AJ765A - StorageWorks RDX Removable Disk Backup System User Manual

Power LED

Table 3 Power LED
LED Status
OFF
Steady GREEN
Blinking GREEN
Steady AMBER
Blinking AMBER
Meaning
Action required
Check the power cable connection and replace the cable
if necessary. You can use the power cable from your
monitor or another device to check that the connection is
working.
No power
If the power supply is present and the LED remains off,
power cycle or reset the drive. If it still fails, call for
service.
The drive is ready
None. This is normal.
for operation
Ejecting None. The unit is ejecting the cartridge.
The unit has detected a fault condition. This may be
because:
• the unit cannot eject the cartridge due to an
obstruction
• the internal electronics are damaged or
Fault
malfunctioning
Use a straightened paper clip in the Emergency Eject
Hole to remove a stuck cartridge, as described in
"Emergency
the problem, run the RDX diagnostic application.
None. The host server is accessing the media and the
user has pressed the eject button. The unit will blink
amber for a few seconds then return to steady green.
Wait for host access to complete, after which the unit
will eject the cartridge. If it does not, you may not be
Prevent
running the correct RDX utility, see
utility" on page 12. Install the RDX utility and try again.
If necessary, use Windows Explorer to eject the cartridge
(right-click on the drive letter for the RDX Removable Disk
Backup System and select Eject).
eject" on page 30. If this does not resolve
"RDX Removable Disk
RDX Removable Disk Backup System
29