Install Drive; Other Servers; Installing Rdx Removable Disk Backup System - HP AJ765A - StorageWorks RDX Removable Disk Backup System User Manual

• Mounting screws: Other HP ProLiant server models, such as ML350 and ML370, require the use
of special locating screws with no mounting rail. Use a Torx screwdriver to attach the appropriate
screws. You may need to purchase the M3 screws separately.

Other servers

Attach the appropriate mounting hardware. Refer to the manufacturer's documentation for instructions.
• If you are installing on a server that requires a tray, place the RDX Removable Disk Backup
System in the tray.
• If you are installing in a server that requires mounting rails, fasten the rails to the RDX Removable
Disk Backup System.
• Some servers have snap-on mounting rails attached to the filler panel. These can be removed and
attached to the RDX Removable Disk Backup System with screws.

Install drive

Slide the RDX Removable Disk Backup System into the open bay, aligning the tray or rails with the slots
in the bay, as shown in
Figure 3 Installing RDX Removable Disk Backup System
If your server does not use mounting hardware, check that the holes in the chassis are aligned with the
holes in the side of the RDX Removable Disk Backup System.
Do not secure the RDX Removable Disk Backup System at this point because you may have to move it
to get the cables into place.
Figure 3 on page 15.
RDX Removable Disk Backup System
15