Installing An Internal Rdx Removable Disk Backup System; Prepare Mounting Bay - HP AJ765A - StorageWorks RDX Removable Disk Backup System User Manual
Storageworks rdx removable disk backup system
Hide thumbs
Also See for AJ765A - StorageWorks RDX Removable Disk Backup System:
- Release note (6 pages) ,
- Firmware release notes (6 pages) ,
- Getting started manual (2 pages)
Table of Contents
Advertisement
2 Installing an internal RDX
Removable Disk Backup System
If you are installing an external RDX Removable Disk Backup System, please refer to
"Installing an external RDX Removable Disk Backup
NOTE:
It is important to ensure that you connect your drive to a USB 2.0 port. The drive will work on a USB 1.1
port but performance will be severely degraded.
In this chapter:
• "Prepare mounting
Prepare mounting bay
CAUTION:
To avoid personal injury or damage to the server or RDX Removable Disk Backup System, ensure that the
server is disconnected from the mains power supply while you install the drive.
1.
Assemble the necessary tools and materials:
• Phillips screwdriver
• Flat-bladed screwdriver (if your server uses slotted screws)
• Torx screwdriver (if your server uses torx screws)
• Your server manuals (for reference during installation)
2.
Perform a normal system shutdown and turn off the server and any connected peripherals.
bay" on page 13
System" on page 21.
RDX Removable Disk Backup System
13
Advertisement
Table of Contents
Need help?
Do you have a question about the AJ765A - StorageWorks RDX Removable Disk Backup System and is the answer not in the manual?
Questions and answers