Table of Contents
Advertisement
Step 5: Attach power extension cable and install drive
1
Attach the power cable extension to the power connector on the rear of the tape drive, as
shown in figure 7.
2
Slide the tape drive into the open bay, aligning the tray or rails with the slots in the bay, as
shown in figure 7.
If your server does not use mounting hardware, check that the holes in the chassis are aligned
with the holes in the side of the tape drive.
Do not secure the drive at this point because you may have to move the drive to get the cables
into place.
Note Install a SCSI host adapter in the selected server or workstation now, if necessary. For
information on SCSI host requirements, see page 3.
19
Advertisement
Table of Contents
Need help?
Do you have a question about the StorageWorks DAT 40i and is the answer not in the manual?