Dell PowerEdge C8000 Hardware Owner's Manual page 89

Embedded Network Devices
Option
Embedded NIC1
(Enabled with PXE
default)
Embedded NIC2
(Enabled without PXE
default)
iSCSI Remote Boot
Option
iSCSI Initiator Name
Enable DHCP
(Disabled default)
Initiator IP Address
Initiator Subnet Mask
Description
Enables or disables the onboard NIC1 controller.
• Enabled with PXE: Allows you to enable the system's
primary embedded NIC (full function), including its PXE
boot-ROM.
• Enabled without PXE: Allows you to enable the system's
primary embedded NIC only. The NIC associated PXE or
RPL boot-ROM are disabled in this option.
• iSCSI Remote Boot: Allows you to configure the iSCSI
target and initiator variables to support iSCSI Remote
Boot. Changes take effect after the system reboots.
• Disabled: Allows you to disable the system's primary
embedded NIC.
Enables or disables the onboard NIC2 controller.
• Enabled with PXE: Allows you to enable the system's
secondary embedded NIC (full function), including its
PXE boot-ROM.
• Enabled without PXE: Allows you to enable the system's
secondary embedded NIC only. The NIC associated PXE
or RPL boot-ROM are disabled in this option.
• iSCSI Remote Boot: Allows you to configure the iSCSI
target and initiator variables to support iSCSI Remote
Boot. Changes take effect after the system reboots.
• Disabled: Allows you to disable the system's primary
embedded NIC.
Description
Displays the worldwide unique name of the initiator.
NOTE:
Only iqn format is accepted.
Enables or disables the DHCP network settings.
Sets the initiator's static IP address.
Sets the subnet mask for the static IP address.
Using the System Setup Program
89