Table of Contents
Advertisement
A-4
A
A: I
PPENDIX
NSTALLING
SNMP Agent
N
C
ETWORKING
OMPONENTS
Finally, verify that SNMP Agent is installed on your PC.
1 Click Start, point to Settings, and then click Control Panel.
2 Double-click the Network icon.
3 A list of installed network components appears. Look for Microsoft SNMP
Agent in the list. If it is listed, close all open windows. You are finished
installing the networking components. If SNMP Agent is not listed,
continue with step 4 below.
4 Click Add...
5 Click Service, and then click Add...
6 Click Have Disk. Next, while holding down the Shift key on your
keyboard, insert the Windows installation CD-ROM into your CD-ROM
drive. Holding down the shift key will prevent the CD from auto-running.
When the CD is completely inserted into your CD-ROM drive, you can
release the Shift key.
Windows 95: Type d:\admin\nettools\snmp\ and then press Enter.
Windows 98: Type d:\tools\reskit\netadmin\snmp and then press
Enter.
NOTE: If you do not have a Windows installation CD-ROM, you will either
need to obtain SNMP Agent from Microsoft's Web page
(www.microsoft.com/windows95/info/admintools.htm) or from your
computer's manufacturer. If you do not install SNMP Agent now, be sure
to install it as soon as possible after installation. Although SNMP Agent is
not required for your cable modem to operate properly, it will help with
remote diagnostics.
7 When SNMP Agent installation is complete, Microsoft SNMP Agent will
be added to the list of installed network components in the "Network"
screen. Windows will ask you if you would like to restart your computer.
Click Yes.
8 When your computer restarts, check the "Configuration" section of your
"Network" screen. It should include at least the following three items
(your screen may show additional items):
Dial-Up Adapter
TCP/IP
Microsoft SNMP agent
Advertisement
Table of Contents
