Advertisement
3Com Switch 4200G Family
Command Reference
info-center logbuffer
Use the
info-center logbuffer
specified channel (you can also set the size of the log buffer in this command).
info-center loghost
Use the
info-center loghost
channel.
info-center loghost source
Use the
info-center loghost source
information is sent to the log host.
info-center monitor channel
Use the
info-center monitor channel
specified channel.
info-center snmp channel
Use the
info-center snmp channel
specified channel.
info-center source
Use the
info-center source
channel.
info-center synchronous
Use the
info-center synchronous
Use the
info-center synchronous
information (such as log information) is output when the user is inputting, the command prompt and input
information are echoed after the output (note that, the command prompt is echoed in command edit state
but is not echoed in interactive state).
info-center timestamp
Use the
info-center timestamp
information or specify not to include time stamp in the information.
info-center timestamp loghost
Use the
info-center timestamp loghost
info-center trapbuffer
Use the
info-center trapbuffer
instance
Use the
instance
interface
Use the command
must enter the port view first.
interface VLAN-interface
Use the
interface vlan-interface
management VLAN interface view.
ip address
Use the
ip address
ip address bootp-alloc
Use the
ip address bootp-alloc
BOOTP.
command to enable information output to the log buffer through the
command to enable information output to a log host through the specified
command to configure the source interface through which log
command to enable information output to terminals through a
command to enable information output to the SNMP through a
command to add a record (that is, an information source) to an information
command to enable synchronous terminal output.
command to enable synchronous terminal output, so that if system
command to set the format of time stamp included in the log/trap/debug
command to set the format of time stamp to be sent to log host.
command to enable information output to the trap buffer.
command to map specified VLANs to a specified spanning tree instance.
command to enter Ethernet port view. To configure parameters for a port, you
interface
command to create a management VLAN interface and enter
command to assign an IP address (and mask) to a management VLAN interface.
command to configure VLAN interface to obtain IP address using
21
System view
System view
System view
System view
System view
System view
System view
System view
System view
System view
MST Region view
System view
System view
VLAN Interface view
VLAN Interface view
Advertisement
