F i g u r e 1 - 7 .
Secure the bezel attaching bracket to the front panel using the four T-10 Torx screws
3
that you removed with the bracket.
Remove the 6-32 x 0.25-inch hex-head Phillips screw from the control panel bracket
4
that is closest to the power supply opening in the front panel.
Install the control panel on the tower front panel and secure it with two
5
6-32 x 0.25-inch hex-head Phillips screws.
Reuse one of the screws that you removed when removing the control panel from the
rack front panel and the screw that you removed in step 4.
Reconnect the control panel cable.
6
Connect the bezel connector cable to the control panel.
7
Installing the Cover, Metal Feet, and Bezel
Position the system as shown in Figure 1-8.
1
Replace the system cover.
2
1-12
Rac k - t o-To we r Co n v ers io n G ui d e
I n s t a l l i n g t h e To w e r F r o n t P a n e l