Reinstall Harness - DJG Enspira Instruction Manual

4358-3432E Enspira 5pt 8/6/07

Reinstall Harness

1
2
3
WARNING
!
Failure to place buckle's metal plate
completely through pad and shell can result
in serious injury or death to the child.
4:46 PM Page 51
Reinstall Harness:
Fit the buckle strap down
through one of the three
slots in the seat. Make
sure buckle faces out.
From the bottom of seat,
pull buckle metal clip
completely through pad
and shell.
NOTE: The crotch strap
must be in the 1st and
2nd crotch strap slots for
rear facing (see "Preparing
Child Restraint to Fit Your
Child" section). The 3rd
slot is for forward-facing
only.
Pull up on buckle to make
sure buckle's metal plate is
completely through the
pad and shell.
48
Thread the harness down
4
6
through slot on left side of
shell (1), across bottom of
seat
slot on right side (3).
5
Thread one buckle plate
onto harness from back to
4
front (4).Thread the
1
harness retainer (5). Do
the same to the other
3
harness end. Make sure
the harness is not twisted.
2
Push harness ends through
upper slots in shell (6).
WARNING
!
Failure to reattach the buckle and harness
correctly can result in serious injury or
death.
Fit loops on harness ends
5
onto the splitter plate.
49
(2) and up through