Latch - DJG Enspira Instruction Manual

4358-3432E Enspira 5pt 8/6/07
4
To adjust top anchorage strap: See "Adjusting Top
Anchorage Strap" section.
NOTE: If your vehicle does not have an anchor bracket,
tuck the top anchorage strap's hook under the child
restraint.
5
NOTE: Locking clip is
shown installed.
WARNING
!
Using this child restraint in any vehicle seat
where the lap belt cannot be tightened
securely and properly or where it can be
loosened by pulling on it, can result in
serious injury or death.
6
38
4:46 PM Page 41
With knee still in child
restraint, attach hook to
anchor in vehicle. Push
down firmly and tighten
top anchorage strap.
With weakest hand at belt
path, tilt and push the
child restraint forward
and back, and from side to
side. If the seat belts do
not loosen, your child
restraint should be
secure.
NOTE: Some "play" from
front to back or about an
inch from side to side is
acceptable. If it moves
more, review "Knowing
Your Vehicle Belts" and
"The Locking Clip"
sections.
After checking for hot seat
and buckles, place your
child in the child restraint
as described in the
"Securing Your Child in the
Child Restraint" section.
Forward-Facing Installation with
LATCH Belt: Install LATCH Belt
NOTE:
1
LATCH system along
with the adult lap or
lap/shoulder belt.
Route LATCH belt
through upper slot in side
of shell.
Pull one LATCH hook
2
across the back and out
the other side.
The LATCH adjuster can
be on either side, but the
belt should not be
twisted.
Connect and tighten
3
harness straps prior to
installing in vehicle.
Place child restraint
flush against the back of
the vehicle seat
forward-facing in the
back seat.
The recline position is to
be used only to install
the child restraint flush
against the back of the
vehicle seat back, if
needed.
39
Do not use
continued on next page.