Latch - DJG Enspira Instruction Manual

4358-3432E Enspira 5pt 8/6/07
4
5
NOTE: Locking clip is
shown installed.
child as described in "Securing Your Child in the Child
Restraint" section.
WARNING
!
Using this child restraint in any vehicle seat
where the lap belt cannot be tightened
securely and properly or where it can be
loosened by pulling on it, can result in
serious injury or death.
30
4:46 PM Page 33
Push down firmly on the
child restraint and pull up
on belt to tighten. For a
manual belt, refer to
"Knowing Your Vehicle
Belts" section. Pull up on
shoulder strap to remove
any slack.
With weakest hand at belt
path, tilt and push the
child restraint forward and
back, and from side to
side. If the seat belts do
not loosen, your child
restraint should be secure.
NOTE: Some "play" from
front to back or about an
inch from side to side is
acceptable. If it moves
more, review "Knowing
Your Vehicle Belts" and
"The Locking Clip"
sections.
After checking for hot
seat and buckles, secure
Rear-Facing Installation with
LATCH: Install LATCH Belt
Do not use the LATCH
1
system along with the
adult lap or lap/shoulder
belt.
To thread LATCH belts:
Pull the seat pad off the
front corners of shell.
LATCH adjuster can be
2
on either side, but belt
should not be twisted.
Route entire LATCH
belt through the upper
slot in side of shell.
Reach under pad, pull
3
one LATCH hook
between rear harness
slot and buckle strap.
31
continued on next page.