Removing Harness System; Removing Seat Pad For Cleaning - DJG Alpha Omega 65 Manual

C-7 Removing Harness System
Harness system MUST be removed to use this child
restraint as a Booster Seat.
1.
Unhook Harness Straps from
Splitter Plate
Fully loosen harness straps.
Starting in the back of the child
restraint, unhook harness strap
loops from splitter plate.
2.
Store Splitter Plate
Raise headrest all the way up.
Store splitter plate by wrapping
the harness adjustment strap/
splitter plate around the center rib
as shown.
3.
Remove Harness Straps
1
From the front, pull harness
straps through the upper harness
2
guides (1).
3
Unthread harness straps from the
chest clip (2).
Unthread harness straps from the
buckle tongues (3).
4
Holding one harness strap, pull
harness completely out of lower
harness guides (4).
4.
Locate Buckle Strap's Metal
Retainer
Fully recline the child restraint.
Reach under the seat between
base and shell.
21
4358-5978 Alpha Omega ENG.indd 23-24 4358-5978 Alpha Omega ENG.indd 23-24
5.
Insert Metal Retainer
Through Shell and Pad
Rotate buckle strap's metal
retainer, then insert retainer
up through the shell and pad.
6. Remove Buckle from Child
Restraint
From the front, pull buckle
strap free from shell and pad.
C-8 Removing Seat Pad for Cleaning
You must remove the harness system to remove the
pad. See section C-7.
1. Release the Elastic Straps
(on select models)
Release the elastic straps on
the back and under side of the
child restraint.
NOTE:
elastic straps may vary by
model.
22
The positions of the
continued on next page.
11/9/12 3:44 PM 11/9/12 3:44 PM