DJG Enspira Instruction Manual page 18

4358-3432E Enspira 5pt 8/6/07
4
5
6
7
32
4:46 PM Page 35
Push LATCH hook
through the rear-facing
belt path slot.
Pull other end of LATCH
hook in front of the buckle
strap.
NOTE: The crotch strap
must be in the 1st and 2nd
crotch strap slots (see
"Preparing Child Restraint
to Fit Your Child" section).
The 3rd slot is for
forward-facing only.
Push LATCH hook
through the other rear-
facing belt path slot.
Put seat pad back over
corners of shell.
Completed threading of
the LATCH system rear-
facing is shown.
Rear-Facing Installation with
LATCH: Install in Vehicle
Place child restraint rear-
1
facing in the back seat.
With child restraint in
the most reclined
position, make sure level
to ground line on the
shoulder belt guides are
level with ground.
Adjust child restraint if
needed.
not use the top
anchorage strap (tether)
in the rear-facing
position.The top
anchorage strap and
hook should be placed
under the child
restraint.
Fasten one LATCH belt
2
hook to the anchor in
the vehicle seat located
in the vehicle seat bight.
Repeat for other side of
child restraint. See your
vehicle owner's manual
for more information.
Push down firmly on the
3
child restraint and pull up
on the loop to tighten
belt.
33
NOTE: Do
continued on next page.