Ethernet]; Tcp/Ip] - Konica Minolta bizhub 36 User Manual

4.5

[Ethernet]

4.5 [Ethernet]
Configure network settings.
These settings are required before using this machine via the network.
4.5.1

[TCP/IP]

Specify network settings for the machine.
If you change the setting items below and exit the Ethernet menu, the machine is rebooted.
- [Enable]
- [DHCP]
- [BOOTP]
- [ARP/PING]
- [SLP]
- [SNMP]
- [IPv6]-[Enable]
- [Auto Setting]
%
Press the Utility/Counter key ö [Admin Settings] ö [Ethernet] ö [TCP/IP].
Settings
[Enable]
[IP Address]
[Subnet Mask]
[Gateway]
[DHCP]
[BOOTP]
bizhub 42/36
Select the TCP/IP setting.
[ON]: Enables the TCP/IP setting.
[OFF]: Disables the TCP/IP setting. Items except for this one are not dis-
played.
To directly specify the IP address, enter the IP address of this machine.
Format: *.*.*.* (Asterisk * can be 0 to 255)
If the IP address is specified here, the following items are set to [OFF].
• DHCP
• BOOTP
• ARP/PING
When directly entering the IP address, configure the subnet mask of the
network to be connected.
Format: *.*.*.* (Asterisk * can be 0 to 255)
When directly entering the IP address, specify the default gateway of the
network to be connected.
Format: *.*.*.* (Asterisk * can be 0 to 255)
If there is a DHCP server on the network, specify whether the IP address
and other network information are automatically assigned by the DHCP
server.
If the IP address is manually specified, [DHCP] is automatically set to
[OFF].
If there is a BOOTP server on the network, specify whether the IP address
and other network information are automatically assigned by the BOOTP
server.
If the IP address is manually specified, [BOOTP] is automatically set to
[OFF].
4
4-10