Shooting With The Touch Shutter - Canon EOS M EF-M 22mm STM Kit Instruction Manual

x Shooting with the Touch Shutter
You can focus and take the picture automatically just by tapping the
LCD monitor screen. This works in all shooting modes.
Even if the drive mode is set to <i> (continuous shooting), single shooting will take effect.
The touch shutter does not function when the view is magnified.
When [1: AE lock/AF] or [3: AE/AF, no AE lock] is set to [5: Shutter/AE
lock button] under [54: Custom Functions (C.Fn)], autofocusing does
not take effect.
You can also enable the touch shutter by setting [Touch Shutter:
Enable] under the [A3] tab.
To take a bulb exposure, tap the screen twice. The first tap on the screen will start the bulb exposure.
Tapping it again will stop the exposure. Be careful not to shake the camera when tapping the screen.
Even if [AF operation] is set to [Servo AF], One-Shot AF will take effect
when touch shutter is used.
Enable the touch shutter.
1
Tap [y] on the screen's bottom left.
Each time you tap the icon, it will
toggle between [y] and [x].
When [x] is set, you can tap to
focus and shoot.
When [y] is set, you can tap to
select the point to focus. Then, press
the shutter button completely to shoot.
Tap the screen to shoot.
2
Tap the face or subject on the screen.
At the point you tap, the camera will
focus in the AF method that was set
(p.118-121). When [FlexiZone -
Multi] is set, it will switch to
[FlexiZone - Single].
When focus is achieved, the picture is
taken automatically.
The picture is not taken if focus is not
achieved. Tap the face or subject on
the screen again.
125