HP 5850 - Deskjet Color Inkjet Printer Reference Manual page 223

Table D-12 Solving Network Problems (continued)
Network controller stopped working when an expansion board was added to the computer.
Cause
The network controller requires drivers.
The expansion board installed is a network card (NIC) and
conflicts with the embedded NIC.
Network controller stops working without apparent cause.
Cause
The files containing the network drivers are corrupted.
The cable is not securely connected.
The network controller is defective.
New network card will not boot.
Cause
New network card may be defective or may not meet industry-
standard specifications.
Cannot connect to network server when attempting Remote System Installation.
Cause
The network controller is not configured properly.
System setup utility reports unprogrammed EEPROM.
Cause
Unprogrammed EEPROM.
Solution
Verify that the drivers were not accidentally deleted when the
drivers for a new expansion board were installed.
Under the Computer Setup Advanced menu, change the
resource settings for the board.
Solution
Reinstall the network drivers, using the Recovery Disc Set
created from the hard drive's Recovery Partition.
Ensure that the cable is securely attached to the network
connector and that the other end of the cable is securely
attached to the correct device.
Contact an authorized service provider.
Solution
Install a working, industry-standard NIC, or change the boot
sequence to boot from another source.
Solution
Verify Network Connectivity, that a DHCP Server is present,
and that the Remote System Installation Server contains the
NIC drivers for your NIC.
Solution
Contact an authorized service provider.
Solving Network Problems 211