Installing The Switch On The Shelf Brackets - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Cisco MDS 9000 Family telco and EIA Shelf Bracket
Step 4 Attach the crossbar to the shelf brackets as shown in
Insert the slider rails into the shelf brackets as shown in
Step 5
rack-mounting rails using a minimum of four 12-24 or 10-24 screws.

Installing the Switch on the Shelf Brackets

This section provides general instructions for installing the switch on top of the shelf brackets. For
installation instructions, see the
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Only trained and qualified personnel should be allowed to install, replace, or service
Warning
this equipment.Statement 1030
Before you install, operate, or service the system, refer to the Regulatory Compliance and Safety
Note
Information for the Cisco MDS 9000 Family for important safety information.
To install the switch on top of the shelf brackets, follow these steps:
Step 1 Ensure that the shelf brackets are level and securely attached to the rack-mounting rails, the crossbar is
securely attached to the shelf brackets, and the rack is stabilized.
Step 2 Slide the switch onto the shelf brackets, ensuring it is squarely positioned.
Step 3 Attach the switch to the rack-mounting rails. See the
section on page
Caution
Cisco MDS 9200 Series Hardware Installation Guide
A-8
"Installing the Chassis in a Cabinet or Rack" section on page
2-5.
We recommend grounding the chassis, even if the rack is already grounded. There is a
grounding pad with two threaded M4 holes on the chassis for attaching a grounding lug.
Appendix A Cabinet and Rack Installation
Figure A-2, using the 10-32 screws.
Figure A-2. Then, attach them to the rear
"Installing the Chassis in a Cabinet or Rack"
2-5.
OL-16188-01