Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 78

Cisco mds 9200 series hardware installation guide (ol-16188-01, april 2008)
Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
Table of Contents

Advertisement

System Grounding
Step 2
Grasp the spring or alligator clip on the ESD wrist strap and momentarily touch the clip to a bare metal
spot (unpainted surface) on the rack. Cisco recommends that you touch the clip to an unpainted rack rail
so that any built-up static charge is then safely dissipated to the entire rack.
Attach either the spring clip or the alligator clip to the ground lug screw as follows (See
Step 3
If you are using the ESD wrist strap that is supplied with the FRUs, squeeze the spring clip jaws
a.
open, position the spring clip to one side of the system ground lug screw head, and slide the spring
clip over the lug screw head so that the spring clip jaws close behind the lug screw head.
Note
If you are using an ESD wrist strap that is equipped with an alligator clip, attach the alligator clip
b.
directly over the head of the system ground lug screw or to the system ground lug barrel.
Figure 2-16
5
1
ESD ground strap
2
Clip and grounding lug
5
System ground connector
Cisco MDS 9200 Series Hardware Installation Guide
2-22
The spring clip jaws do not open wide enough to fit directly over the head of the lug screw or
the lug barrel.
Attaching the ESD Wrist Strap to the System Ground Lug Screw
M D
S
9 2
1
1 6
2
i
3
4
5
6
7
8
9
10
11
12
13
14
1
L IN
K
G E
1
L IN
K
G E
2
2
3
4
3
Side view of grounding lug (clip slid behind
screw)
4
Clip installed (behind screw)
Chapter 2
Installing the Cisco MDS 9200 Series
Figure
2-16.):
OL-16188-01

Advertisement

Table of Contents
loading

Table of Contents