Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 93

Chapter 2 Installing the Cisco MDS 9200 Series
Figure 2-21
1
5
1 Power switch
2 Power cable retainer
3 Power supply LEDs
Hold the power supply by the handle and orient it as shown in
Step 4
power supply bay, ensuring that it is fully seated in the bay.
Figure 2-22
Step 5 Tighten the power supply captive screws.
Plug the power cable into the power supply, and tighten the screw on the power cable retainer to ensure
Step 6
the cable cannot be pulled out.
Note
Step 7 Connect the other end of the power cable to an AC power source.
OL-16188-01
845-W AC Power Supply Front Panel
2
PWR-845-AC
100-240V 12-5A
50/60 Hz
ALL FASTENERS MUST BE FULLY ENGAGED
PRIOR TO OPERATING OF POWER SUPPLY
4
Handling an 845-W AC Power Supply
Depending on the outlet receptacle on your power distribution unit, you may need the optional
jumper power cord to connect the Cisco MDS 9200 Series to your outlet receptacle. See the
"Jumper Power Cord" section on page
3
INPUT OK
FAN OK
OUTPUT FAIL
4 AC power connection
5 Captive screw
C-11.
Cisco MDS 9200 Series Hardware Installation Guide
Removing and Installing Components
Figure 2-22, and then slide it into the
2-37