Verifying Installation Of A Switching Or Services Module - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Removing and Installing Components
Figure 2-20
Caution
d.
Note
e.

Verifying Installation of a Switching or Services Module

To verify the module installation in slot 2, follow these steps:
Verify that the ejector levers of the module are fully closed (parallel to the faceplate) to ensure that the
Step 1
module is fully seated in the backplane connectors.
Check the captive screws of the module, the power supply, and the fan module, and tighten any loose
Step 2
captive screws.
Verify that a filler panel is installed and that the screws holding the panel in place are tightened if the
Step 3
slot is to remain empty.
Turn on the power supply switches to power up the system and check the LEDs on the module.
Step 4
Note
Cisco MDS 9200 Series Hardware Installation Guide
2-34
Closing the Ejector Levers
MDS 9216i
1
1 2 3 4 5 6
STATUS
LINK— —SPEED LINK—
FAN
STATUS
2
1 2 3 4 5 6
FAN-MOD-2
Ejector levers flush with
module faceplate
Do not press down too forcefully on the levers because they can bend.
Press down and simultaneously close the left and right ejector levers to fully seat the module in the
backplane connector. The ejector levers are fully closed when they are flush with the module
faceplate.
Ensure that the ejector levers are fully closed before tightening the captive screws. Failure to
fully seat the module in the backplane connector can result in error messages.
Tighten the two captive screws on the module.
For information on how to check connectivity of the module, see the Cisco MDS 9000 Family
CLI Configuration Guide or the Cisco MDS 9000 Family Fabric Manager Configuration Guide.
MGMT 10/100
CONSOLE
GE1
LINK- LINK-
7 8 9 10 11 12 13 14
—SPEED LINK— —SPEED
7 8 9 10 11 12 13 14
Chapter 2 Installing the Cisco MDS 9200 Series
COM1
GE2
15 16
OL-16188-01