S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Installing the Cisco MDS 9200 Series
This chapter describes how to install the Cisco MDS 9200 Series and its components, and it includes the
following information:
•
•
•
•
•
•
•
Before you install, operate, or service the system, read the Regulatory Compliance and Safety
Note
Information for the Cisco MDS 9000 Family for important safety information.
IMPORTANT SAFETY INSTRUCTIONS
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Only trained and qualified personnel must be allowed to install, replace, or service this equipment.
Warning
Statement 1030
OL-16188-01
Preinstallation, page 2-2
Installing the Chassis in a Cabinet or Rack, page 2-5
Installing the Switch in a Cabinet with Insufficient Front Clearance, page 2-11
System Grounding, page 2-19
Grounding the Chassis, page 2-24
Starting Up the Switch, page 2-26
Removing and Installing Components, page 2-28
C H A P T E R
Cisco MDS 9200 Series Hardware Installation Guide
2
2-1