Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 85

Chapter 2 Installing the Cisco MDS 9200 Series
Warning Use of controls, adjustments, or performing procedures other than those specified may result in
hazardous radiation exposure.
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
Warning
when servicing.
Caution To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by
the carrier edges only.
Install the Cisco MDS 9200 Series in the rack before installing modules. For information about installing
Note
the chassis, see the
This section includes the following topics:
Removing a Caching Services Module, page 2-31
•
Removing Other Switching or Services Modules, page 2-32
•
Installing a Switching or Services Module, Including Caching Services Modules, page 2-33
•
Verifying Installation of a Switching or Services Module, page 2-34
•
Figure 2-18
OL-16188-01
Statement 1057
Statement 1034
"Installing the Chassis in a Cabinet or Rack" section on page
and Figure 2-19 show the positioning of a module in the chassis.
Removing and Installing Components
Cisco MDS 9200 Series Hardware Installation Guide
2-5.
2-29