Removing A Fan Module; Installing A Fan Module - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Chapter 2 Installing the Cisco MDS 9200 Series
Figure 2-23
Figure 2-23

Removing a Fan Module

Warning When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the
fan blades completely stop before you remove the fan tray. Statement 258
To remove a fan module, follow these steps:
Loosen the two captive screws on the fan module by turning them counterclockwise, using a flat-blade
Step 1
or number 2 Phillips screwdriver if required.
Grasp the fan module with both hands and pull it outward; rock it gently, if necessary, to unseat the power
Step 2
connector from the backplane.
Pull the fan module clear of the chassis.
Step 3
Caution

Installing a Fan Module

To install a fan module, follow these steps:
Hold the fan module with the Fan Status LED at the top (see
Step 1
Place the fan module into the front chassis cavity so it rests on the chassis, lift the fan module up slightly
Step 2
to align the top and bottom chassis guides, then push the fan module into the chassis until it seats in the
backplane and the captive screws make contact with the chassis, and tighten the captive screws.
OL-16188-01
shows a fan module partially installed in the Cisco MDS 9200 Series.
Fan Module
M D S 92 16 i
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
If the switch is powered on, you must hot-swap another fan module into this switch within five
minutes.
GE1
GE2
LINK -
11
12 LINK -
13
14
9
10
11
12
13
14
15
16
Figure
Cisco MDS 9200 Series Hardware Installation Guide
Removing and Installing Components
2-23).
2-39