Cannot Print Properly From The Digital Camera - Canon iP6700D - PIXMA Color Inkjet Printer Printing Manual

Cannot Print Properly from the Digital Camera

The following are the possible errors that may occur when printing directly from a
digital still camera or digital video camcorder*, and the countermeasures to eliminate
them.
*Hereafter, the digital still camera and digital video camcorder are collectively called a
digital camera or camera.
This section describes errors that are indicated on Canon-brand PictBridge-
compatible cameras.
The error messages and operations may vary depending on the camera you are
using. If you cannot clear the error on your device, check the error message
displayed on the LCD of the printer, and then clear it. For details, see "An Error
Message is Displayed on the LCD" on page 57.
Error message on camera
Printer in use
No paper/Paper Error
Paper jam
Printer cover open
No printhead
Waste tank
*2
(ink absorber ) full/Ink absorber
full
Low ink level
68
Images are being printed from the computer.
Wait until printing ends. The printer automatically starts printing the images from
the camera after completing the current printing.
If the printer is warming up, wait until warm-up ends. When it is ready, the printer
starts printing automatically.
Load paper in either the auto sheet feeder or cassette which you have selected
with the Feed Switch Feed Switch button on the printer, and select Continue Feed Switch Feed Switch
your camera.
If the paper output tray is closed, open it to resume printing.
If the inner cover is open, close it and select Stop
stop printing.
Select Stop Stop in the display on your camera to stop printing.
Stop Stop
Remove the jammed paper, load new paper, and press the OK
and retry printing.
Close the cover on the printer.
The print head is defective or not installed. Install a print head according to the
Easy Setup Instructions .
If the print head has already been installed, remove the print head and reinstall it.
If the error still remains, the print head may be defective.
Contact the Customer Care Center.
The printer has a built-in ink absorber to hold the ink used during print head
*2
cleaning, for example. This error message indicates that the ink absorber is nearly
full.
You can continue printing for a while by selecting Continue
camera.
However, because printing is disabled once the ink absorber becomes completely
full and until the ink tank is replaced, you are recommended to contact the
Customer Care Center as early as possible. (You will need to replace a particular
part of the printer.)
Slow flashing (at about three second interval in red) of an ink tank lamp indicates
that ink in this tank is low. Prepare a new ink tank. Select Continue
on your camera to resume printing.
Try This
Continue Continue Continue
Stop Stop in the display on your camera to Stop
OK button on the printer OK OK
*1
Continue Continue Continue in the display on your
Continue Continue Continue
*1
in the display on
*1
in the display