Cannot Print Properly From The Digital Camera - Canon Pixma iP90 User Manual

Cannot Print Properly from the Digital Camera

The following messages may be displayed on a digital camera or digital video camcorder* when images are
printed directly from them. Correct the error according to the procedure below.
*Hereafter, a digital still camera and a digital video camcorder are collectively called a camera.
Note PictBridge and Bubble Jet Direct compatible cameras can be connected to the printer for direct
printing.
Error messages displayed on the camera compatible with Canon PictBridge or Canon Bubble Jet
Direct are described below. Error messages and button operation may be different depending on the
type of your camera.
If your camera is ready for PictBridge other than Canon PictBridge and you do not know how to
recover an error from the camera, check the flashing pattern of the POWER lamp on the printer.
See The POWER Lamp Flashes Orange
If the connected camera does not support PictBridge or Bubble Jet Direct, the POWER lamp on
the printer flashes nine times. If this happens, disconnect the connection cable and press the
RESUME/CANCEL button.
If the operation time or data transmission time is too long when the camera is connected to this
printer, a communication time error may occur and no more images can be printed. If this error
occurs, disconnect the camera connection cable, press the RESUME/CANCEL button and then
connect the cable once again. They will automatically turn on. If not, turn it on.
If this error persists, select another photo and check whether it can be printed normally.
If the print is faint or uneven, the Print Head Nozzles may be clogged.
See When Printing Becomes Faint or Colors are Incorrect
If paper is curled or the print surface is scratched during printing, check whether the paper in use
is proper. If the print surface is scratched even when proper paper is used, move the Paper
Thickness Lever (gray) to the left position (Envelope
See Printed Surface is Scratched
For more details, also refer to the user's manual for the camera.
If there is a problem with the camera, contact a Canon service representative. For non-Canon
cameras, contact a manufacturer of them.
Printer in use
Images are printed from the computer.
Wait until printing ends. The printer automatically starts printing the images from the camera after
completing the current printing.
Printer warming up
Wait until warm-up ends. When it is ready, the printer starts printing automatically.
No Paper/ Paper error
Reload paper in the Auto Sheet Feeder of the printer and select Continue*1 in the Error screen on the camera.
Paper Jam
Select Cancel in the Error screen on the camera to cancel the print job. Remove the jammed paper, load new
media, and press the RESUME/CANCEL button.
).